How to show IOS version in CISCO Router and Switches
CISCO routers and switches use the same set of commands and resembles very much to LINUX commands. You just need to remember the command and you will always remain the CHAMP. Commands are given as under to show the IOS and hardware information on CISCO router and switches:
Command:
show version
or
show hardware
June 30, 2012 @ 6:51 am
Very good article. I will be experiencing a few of these issues as well.
.
May 31, 2013 @ 7:54 pm
I imagine these Cisco IOS router commands are universal on all Cisco router and switch series?
May 31, 2013 @ 7:56 pm
Oh wait, Cisco’s IOS is similar to Juniper Junos.
You can also find more information on Cisco Routers and Cisco Switches at Vology.
July 20, 2013 @ 4:43 pm
Yesterday, while I was at work, my cousin stole my iPad and
tested to see if it can survive a 30 foot drop, just so she can be a youtube sensation.
My iPad is now destroyed and she has 83 views.
I know this is entirely off topic but I had to share it with
someone!
September 1, 2013 @ 3:07 am
Article writing is also a fun, if you be acquainted with afterward you can write if not it is
difficult to write.
October 24, 2013 @ 11:04 pm
Thanks a bunch for sharing this with all folks you really recognize what you are speaking approximately!
Bookmarked. Kindly also seek advice from my website =). We can have a hyperlink exchange contract among us